The yellow should turn to black again with a very thin outline of red. Make sure "High Pass Filter is checked an the "Value" is set to 300. On the right side of the page it should say "High Pass Filter" and below that "Value". When they are all selected they should turn yellow. The reason for fitting so many into one page is to save vinyl.Īfter you have fit as many 1/20 fractions into the cutting area as you could, you the "Trace" tool to select all of the fractions. The "Replicate" tool at the top of the page may help you do this. Make sure they do not overlap each other.
This may require you to move them around a bit to get them all to fit. In my case, that meant 5 times, because I was able to fit 5 of them into my 12in by 8in cutting area. After you have matched the height of the fraction to the diameter of your metal disc, you will need to duplicate the image several times until the page is filled with them. Be sure that the "Lock Aspect" box is checked this will keep the width and height proportional to each other. In order to have the vinyl fit your metal disc, use the "Scale" tool to scale it's height to match the diameter of your metal disc.
#MAGNETIC DART BOARD DOWNLOAD#
Next, download the black fraction image found in this step and import into your Silhouette Studio project. In other words, if you are using 12in-wide vinyl rolls, set the width to 12in and the length to 8in. For example, I have rolls of vinyl that are 12 inches long, so I set the width on Silhouette Studio to 12in and the length to 8in because I will cut 8in long strips of vinyl.
After creating a new file, click the "Page Settings" tool at the top of the page to set the dimensions of your project to match the size of the vinyl you are using (12in by 8in is recommended).
Start by opening up a new Silhouette Studio file on your computer.
0 kommentar(er)
